I remember how frustrating getting my first pull-up was. There were times just spent looking up at the bar and wondering why I simply wasn't moving.

The best way I found to finally get my chin over the bar was a combination of similar but easier movements, combined with variations which took away a lot of my bodyweight.

Let's break each of those exercises down:

Australian Pull-Up

This is a horizontal row which gets you used to pulling your bodyweight. With your feet on the floor you can easily adjust the assistance you give yourself. The more horizontal you are and the further away your feet are from your hands, the harder it is.

The horizontal position should make it a bit easier for you to engage your lats. Try to keep your body straight and not bend at the hip as you pull.

Negative Pull-Up

This uses the full range of motion of the pull-up, but in reverse! It's no secret that the eccentric (negative) part of any movement builds a lot of strength, and pull-ups are no different. Learning to control that entire range on the way down will carry over to when you're going back up.

If you jump up and immediately start to fall, build yourself up to a comfortable 10-second hold with your chin over the bar (the "top" of the rep) before you start doing the negative.

Low-Bar Pull-Up

Like the Australian pull-up, you can adjust how much of your bodyweight you remove by assisting yourself with the feet. Ideally you want to be on the tiptoes or the backs of your toes rather than the ball of your foot, encouraging you to use as little assistance as possible.

This is where your technique starts to come into play and you need to focus on engaging your lats for the pull, not using the biceps which is a common beginner mistake. (See A Quick Fix For Better Lats for more info.) Think about pressing into the bar from your lats or "bending the bar." Play around until you can feel your lats working.

Banded Pull-Up

These often get a bad rap because when the band is at full extension it will give you the most assistance. This means you get the most help at the bottom of the rep which reduces the need for you to learn how to initiate the pull with your lats.

However, they're great for volume. You just need to be disciplined. Be hard on yourself and only use a band which will allow your 5 reps to be doable, but not easy. Even if you start to only get 3 or 4 reps on your last set, it's better to push yourself here than simply be bouncing up and down on a band – that will get you nowhere.

Eventually you want to be doing these with a very thin band. Once you're getting close, attempt a rep or two without a band. You might just surprise yourself.

The program is simple and organizes the movements into two quick sessions that you can easily fit into your gym schedule:

Session 1

• Australian Pull-Up: 3x10
• Negative Pull-Up: 5x3

Session 2

• Low-Bar Pull-Up: 5x5
• Banded Pull-Up: 5x5

Adjust the assistance of each exercise to reduce your bodyweight so that you can complete all the reps.

Your aim over time isn't necessarily to increase the reps or sets that you do, but instead to improve the movement itself and slowly adding in more of your own weight. For example, you'd aim to get more horizontal on the Australian pull-up, go slower on your negative, use less assistance from your feet on the low-bar pull-up, and use a thinner band on your banded pull-up.

Consistency is key. Bodyweight training can be tedious, but the rewards are very satisfying. Pull-ups teach you how to properly engage your lats and give you a ton of shoulder stability for any overhead movements.